Dive Rite O2ptima Guía de usuario descargar pdf (Pagina 36)

measurements for each sensor. Any individual sensor out of range will be voted out. The

voting logic used in both the primary and secondary handsets is identical. Any sensor that

is 15% out of range from the average of the remaining two sensors will be voted out. The

second, third and fourth screenshots show sensor one voted out. The second screenshot

shows system status of <WARN>, this is indicated if any sensor is voted out or average

po2 is at least 15% from selected set-point. The next screen shot shows an error of at least

25%, so ALERT is indicated. The last screen shows a status that no diver wishes to see,

PO2 ERROR, this will be indicated if the average PO

reaches 1.8 or is 0.19 and below,

the RED LED and the backlight are illuminated.

Handset Options and Programming

The additional functions in both the primary and

secondary are accessed by scrolling past the set-point

selections using the left button. On the primary, the first

option available is the gas selection prompt. Pressing

the right button will select this function. Each press of

the left button scrolls to the next programmed gas mix

until all 10 are displayed, eventually returning to first

mix. Once the desired mix is displayed, pressing the

right button will select it. The diver will then be

prompted to confirm or cancel the mix change. Pressing

the left button confirms the selection, while the right

button cancels the switch

The next selection is the FO2 display screen.

Pressing the right button will immediately display the

calculated PO

for the current diluent and current depth.

A proper loop flush with diluent should result in this

value.

GAS

NEXT SELECT

AIR 21/ 0

NEXT SELECT

FO2

NEXT SELECT

Diluent ppO2 is:

0.22

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 44 45

Sin comentarios

Dive Rite O2ptima Guía de usuario Pagina 36